WIP, need help!

Hylian · Post by **Hylian** » Fri Jun 18, 2004 6:59 pm

Im working on a map in Gmax but there are some problems at hand.

1.whenever i try to export the map using chimp,I get an error saying "frame object was not found"

2.when I run sapien, it just freezes

someone please give feedback.

Burnination · Post by **Burnination** » Fri Jun 18, 2004 7:09 pm

1. make a small box and then name it frame...then link everythink to it...
2. Not sure...usually it takes a couple of minutes to boot up

Hylian · Post by **Hylian** » Fri Jun 18, 2004 7:23 pm

now it says there is no geometry linked to frame

gecko753 · Post by **gecko753** » Fri Jun 18, 2004 7:25 pm

did u link the object to the frame right?

Hylian · Post by **Hylian** » Fri Jun 18, 2004 7:30 pm

im not sure.all the geometry is attatched attached to the frame but i still get the popup.

edit:just figured it out

Burnination · Post by **Burnination** » Fri Jun 18, 2004 7:56 pm

nope, like this....sry bout the map...its not even a map...i just map it so i could show you...

ps....you might need to make it bigger..to read the font

Hylian · Post by **Hylian** » Fri Jun 18, 2004 8:17 pm

the data is writing right now,i ts taking kinda long

Hylian · Post by **Hylian** » Sat Jun 19, 2004 9:14 am

Ok, so it finished writing the data,and I fixed the jms file just like it says in the chimp read me, but I cant get it to work in tool.when I open up tool it closes a second later

hydroxic · Post by **hydroxic** » Sat Jun 19, 2004 10:06 am

you have to use a command prompt to open tool, or u could use HEKter, go to nitrous.halocity.org for that...

GHL · Post by **GHL** » Tue Jun 22, 2004 5:57 am

OMG STOP!
dont have the frame inside the level geometry!
move it far out quick!

Hylian · Post by **Hylian** » Wed Jun 23, 2004 3:07 pm

the frame is outside of the map.anyway,I got HEKter running,but its taking long,is it supposed to take long or is something wrong.