swapping FP models

bumlove · Post by **bumlove** » Thu Nov 08, 2007 12:46 pm

a straight forward question for a change I have a plasma pistol that shoots grenades (looks and acts like thrown grenades) I would like the FP model to look like FP bomb model
I tried the few ways I figured it could work but I'm rubbish can anyone direct me to the right tut
also I would like to change the FP bomb model so it looks like you are holding a backpack (bloc) how do I do this

Rockymods · Post by **Rockymods** » Thu Nov 08, 2007 2:53 pm

Go to the [weap] of the plasma pistol. In there, there are two [mode] references. Swap those two

bumlove · Post by **bumlove** » Thu Nov 08, 2007 4:18 pm

that what I thought it would be so I tried that (only swapping model 0 as I only play as MC) and I ended up with invisible hands and gun will try again after sleeeeeeeeeeeep

mr_penguin · Post by **mr_penguin** » Thu Nov 08, 2007 4:44 pm

There are three, swap everyone. What map is it because I have problems with models on ascension.

bumlove · Post by **bumlove** » Fri Nov 09, 2007 12:59 am

its been tried on cyclotron and colossus, I'm aware of the ascension problem (invivisble players except head and gun I think) me and another guy had the same problem ages ago both of us doing different stuff and the reply I got got from zone117 at another forum was "VOMG you guys are such noobs! you both messed up somewhere, Im not helping if you don't know what you're doing"
erm yeah thanks a lot zone
anyway change all 3 idents that point to mode then?