Skinning Problem

FFIIMan · Post by **FFIIMan** » Sat Jun 30, 2007 8:35 pm

i just injected a .dds in coagulation using entity, for the bannar and surprise now its fucked up. Whenever i try to select that bitmap it gives me the .framework error and closes entity. Does anyone know how i can fix this, I tried to reinject with dothalo, my dothalo is fucked up, i reinjected the original using ADI, went back into entity and its still fucked, anybody know how i can fix?

mr_penguin · Post by **mr_penguin** » Sat Jun 30, 2007 10:39 pm

you may need to us a clean map again, if you've done a lot to the map you should of made backups along the way.

The only way I think you can fix the problem is to either use a different entity or try to edit the map without entity. And if all that fails than you may need to start over and get a new clean map.

try entity 1.3.9
entity 1.4
entity 1.6

one of those should work

ScottyGEE · Post by **ScottyGEE** » Sat Jun 30, 2007 11:21 pm

I gots an idea! don't use entity for skinning! use adi, dothalo or ch2r. Yes they are old but they all have good skinning capabilities with minimal fuck ups (ch2r is the best of them though)...

Start on a new map I'd recommend though

SpecOp44 · Post by **SpecOp44** » Sun Jul 01, 2007 5:07 am

Scotty's idea would be better. As if you inject a bitmap in the wrong format, it gives you an error every time you select it, and messes up that bitmap.

bibbit · Post by **bibbit** » Mon Jul 02, 2007 8:16 am

Entity 1.4 usually works for me, but I mostly use Dothalo.