What is different with the collision in Containment?

selyb · Post by **selyb** » Thu Jul 20, 2006 5:58 am

i released some new invisible barrier patches on the files forum and there are only two things keeping me from completing the set
one is a single invisible barrier on Zanzibar
if you are looking at the beach, its all the way right, agains the big wall

the other is the entire map of containment
i used entity to export the collision mesh as an obj and imported into milkshape
when i view it, the barriers keeping you from getting out of the level are not there

does anyone have any information on these?

Twinbird24 · Post by **Twinbird24** » Thu Jul 20, 2006 7:14 am

All the collision barriers are there, sometimes they're not as noticable. Just try and find them. Look at the maps from a top and side angle and you'll see the invisible walls. They're usually near the top or the side, or both...

selyb · Post by **selyb** » Thu Jul 20, 2006 1:03 pm

i know this isnt the case with zanzibar
the patches released before had every high point dropped below the level and that wall was still there

ill check containment again but im pretty sure that they werent there

edit:
they arent there on containment
could you show me a shot where you do see them?
i mean... i dont see any barriers except for the very top which makes the ceiling for the level and the outer walls
i see no invis barriers above the cliff edges or anywhere else internally

edit2:

just to be sure, i got the original from the map disc and i still dont see them

Twinbird24 · Post by **Twinbird24** » Thu Jul 20, 2006 2:22 pm

I see all the invisible walls in Containment and Zanzibar just fine. Use Entitys Collision Vewer to find them. Just go to the sbsp tag, click on the bsp, then click on the plus sign then BSP Collision>Collision Viewer. Look at this picture of Zanzibar below:

selyb · Post by **selyb** » Thu Jul 20, 2006 5:45 pm

i dont want to remove the ceiling, then when you jump, youll die
the invis barrier patches that were released previously did that and it sucked
thats why i released mine, so you can get out of the level and not fall off the edges or die when you accidently jump too high or whatever

yes, i can see those
im referring to the invisible barriers that keep you from getting on top of the cliffs on containment
in containment, i can only see the ceiling and exterior walls, i cant see any interior barriers
this is the internal barrier i removed on zanzibar

this is where the barrier sits that i cant seem to affect