Pelican!!!!!!!!!

maxipulhalo2 · Post by **maxipulhalo2** » Tue Mar 16, 2004 4:14 pm

here is exactly what i did, i went to the vehical tap, i clicked swap, and swapped with the pelican, then since it would just make the warthog fly without the pelican model, i coppied the pelican model, and pasted that over the warthog model. now echo 419 brings the pelican, it doesnt fall through the ground but the only seats that i can get in are the gunner seat and the passenger seat, and those are in like the very back of the pelican model. You know how when you are close enough to enter a vehical it pops up some text that says press e to enter gunner seat or somthin like that. Well i go all around and through the model of the pelican and it never pops up saying press e to enter driver seat. it only has the passenger seat and the gunner seat. Its like there didnt even put a driver seat on it.

HunterXI · Post by **HunterXI** » Tue Mar 16, 2004 4:16 pm

hmmm, why did you swap the models?!? you wont have to do that! wait, that should've caused a M.E....

I dont think you have to swap the models. replace the map, and try again.

maxipulhalo2 · Post by **maxipulhalo2** » Tue Mar 16, 2004 4:19 pm

if i just go and swap the meta of the warthog with the pelican, echo 419 just brings me a flying warthog. It does not look like a pelican, it is just your average flying car

wait a sec, i figured it out. i have no idea what i was doing rong, but i figured it out now, thnx ppl

HunterXI · Post by **HunterXI** » Tue Mar 16, 2004 4:24 pm

HunterXI
/\ /\ /\ /\
wierded out... I always just copied the Peli meta, pasted it on the Warthog meta, saved, and could fly it (after the other changes)...