Optimize Modifier

Patrickssj6 · Post by **Patrickssj6** » Sun May 08, 2005 11:21 am

Is there a way where i can apply the Optimize Modifier to certain faces only?

Gavel · Post by **Gavel** » Sat May 14, 2005 6:55 am

I don't think so, try going into face selection mode, and clicking optimize modifier. Might not work because, max always just applies it, and takes you out of the mode.

BTW try not to use that modifier, it can screw up your models. Say you have a very thin door. You use optimize and it might make that door weird. I can;t explain it, but it deletes some of the croner vertices, and makes it thin and odd.

Patrickssj6 · Post by **Patrickssj6** » Sat May 14, 2005 7:12 am

no it worked.i aked sonictag and it worked but i got some errors but thank anyway

Gavel · Post by **Gavel** » Sat May 14, 2005 7:39 am

Ah, ok.

Waverunner · Post by **Waverunner** » Sat May 14, 2005 7:40 am

Patrickssj6 wrote:no it worked.i aked sonictag and it worked but i got some errors but thank anyway

How did you do it?

Also, why is this in mapping? (lol?)

Patrickssj6 · Post by **Patrickssj6** » Sat May 14, 2005 7:45 am

select faces optimize modifier and then convert to editable mech like the uvw mapping