Change flamethrower to ghost

Ice · Post by **Ice** » Tue Jul 27, 2004 11:04 pm

Ok, I'll admit, I am a noob. Heck, I just started today, but I want to know how I can change the flamethrower in blood gulch to a ghost using Halo Map Tools V3. Thanks

HunterXI · Post by **HunterXI** » Wed Jul 28, 2004 4:04 am

well, better to be up front about it! This is a good time for you to learn offset/meta swapping, the most basic concept of Halo. The tut is here:
http://www.halomods.com/site2/geeklog-1 ... 3053106260

also note that the link to Iron Forge's offsets is broken and doesn't work anymore, you can find a working link for them in the Sticky titled "Iron Forges Offsets... Download Here:" at the top of this forum.

Hope I helped

Ice · Post by **Ice** » Wed Jul 28, 2004 10:20 am

I can do a little bit of swapping and such, but I want to replace the entire flamethrower to a ghost. Like when you go into the cave instead of a flamethrower being there, I want a ghost to be waiting there for you. I tried putting the ID number for the ghost for the flamethrower, and it was in the cave, but you couldn't drive it. It would be on, and you could get in, but it wouldn't move. You could fire the gun, but it would only shoot straight or off to the side a little bit, and wouldnt stop even if you got out. What do I need to do to make the ghost drivable? Thanks

EqUiNoX · Post by **EqUiNoX** » Wed Jul 28, 2004 11:45 am

Just swap the weapon data with the vehicle data...

Ice · Post by **Ice** » Thu Jul 29, 2004 9:41 am

K, thanks all!

D3V0N · Post by **D3V0N** » Mon Aug 02, 2004 10:50 pm

Topic Cleaned. Problem Solved. Do not post in a thread unless it helps the author [really]. Problem was solved but spamming continued. Do not do this people it's not that hard. Mods shouldn't have to clean up so much. Thx.