HaloMods "Classic" Read-only Archive

hey, i tried getting this to work...

i load the xord trainer launcher
halo2 pops up in the games menue
i just press A and nothing happens
of course when i press X it says "Xord Loading"
Halo 2 launches
but when i go to take screen caps (ie: rthumb+back, or rthumb+lthumb) it does'nt seem like anything is happining...so i go back to my Uber Screencap Tool (which says is still connected) and nothing shows up...so iv re-connected it and i still get nothing....AAHH...WHATS GOING ON!!!???

I don't even get any pictures in the $s file i setup in the TDATA folder

WHY NOT?

can you fly around in dev-cam or go third person, if not the trainer isn't launching.

Use the newest version of Xored.

a mammoth wrote:can you fly around in dev-cam or go third person, if not the trainer isn't launching.

no...it just acts like regular old halo

Make sure your trainers are in the right place.
I had the same problem and I copied a the trainers into another one of the many trainer folders on my HDD and it worked.

FleetAdmiralBacon wrote:Make sure your trainers are in the right place.
I had the same problem and I copied a the trainers into another one of the many trainer folders on my HDD and it worked.

all i did was take the two etm files...pasted them into the mini xord launcher folder, and pasted that file into the apps on the HDD...i hope thats the right place because it lets me acess it through the dashboard, and launch halo2, but i don't have the devcam mode you all got

do you have an E:\trainers folder?
If so, put them in there.