Ive searched and cant seem to find what Im looking for. Ive modded Halo 2 and been playing it on my xbox one. What is the process to play it on my xbox 360.
THANKS FOR ANY HELP or pointing me in the right direction.
I have my xbox 360 firmware modded, but cant seem to figure out how I modify the Halo 2 iso by adding modded boards - like I did with the xbox one version.
look, when you modified halo 2 you didnt modify the actual disc, thats impossible because its copy protected, you were processing data that was on a mod chip, you have to start from scratch on your 360 again, or if it is mod-chipped transfer your mods onto that, was that any help at all? but like coco-fang said : refer to www.xbox-scene.com
i guess you could say i 'modded' my xbox 360... but i only have access to the downloaded maps this way. i need a modded dash to get it access to the old maps
The iso is an "picture" (if you will) of the disk (exact copy - byte by byte). You need to extract it with XISO and then you copy those files on to the hard drive of the Xbox.
So when you're modding a 360 and using it to play Halo 2, I was always under the impression that you were just stream lining from your PC, that you don't actually have to crack the case on the 360 to mod it since it's so PC friendly this time around.
You need to take the modded Halo 2 that you have on your Xbox 1 and use a program like Craxtion4 to make an xISO. You will not need the credits_60.bik, and the singleplayer maps. If you try to put these in your xISO it may (most likely will) make it too big to fit on a DVD. I read that there is a new firmware hack for the Xbox 360 that they have not released yet, and without it, you can't play burned games on the Xbox 360.
but like coco-fang said : refer to www.xbox-scene.com
