control of zanzibar gate

ahlgero · Post by **ahlgero** » Sat Jun 03, 2006 8:49 pm

I have just added another zanzibar gate and put it into place with entity, but I cannot figure out how to open it. The original works just fine, but I was thinking that I could duplicate the control computer and put it some where else and tie it to the duped zanzibar gate. If I could do that, which tag is the control panel under?

Thanks,
ahlgero

EDIT: Ok, I found that the gate control is under the [ctrl] tag! DUH!

WaywornMmmmm · Post by **WaywornMmmmm** » Sun Jun 04, 2006 5:50 am

That seems like it would work.

DeviousDave · Post by **DeviousDave** » Sun Jun 04, 2006 5:53 am

Yeah, as long as you dupe the controll correctly and link it it should work.

ahlgero · Post by **ahlgero** » Sun Jun 04, 2006 12:56 pm

ok im lost. I have no idea how to tie the new ctrl to the new gate. Can someone please help?

Twinbird24 · Post by **Twinbird24** » Sun Jun 04, 2006 2:05 pm

I'm not quiet sure how you do it. Did you add chunks to the map and add the gate that way? Also, I have a question. I added scenary and objective (teleporters and thier scenary) and they don't show up in the map,but they show up in the bsp viewer. Anyways...

ahlgero · Post by **ahlgero** » Sun Jun 04, 2006 2:42 pm

I don't know...I'm gonna abandon this before it gets too complicated.

DeviousDave · Post by **DeviousDave** » Sun Jun 04, 2006 9:13 pm

don't, you'll never get better...