I replaced a warthog passenger boarding seat with a passenger seat. Now I want to move the seat to the back of the hog and orient the person in the seat to face behind the hog (I already nulled out the turret).
How can I move seats? (in noob terms if at all possible)
How can I move a seat's markers?
-
- Posts: 18
- Joined: Sun May 14, 2006 9:19 am
How can I move a seat's markers?
Last edited by augie doggy2 on Mon May 15, 2006 5:30 pm, edited 2 times in total.
Use this plugin. Find the marker the seat is attached to (something like warthog_p_b I think) and change its coords to about where the turret's coords are.
Alternately, you could null it, then rename the turret marker to warthog_p_b and just rotate it by 3.142.
Also, if you lean its pitch back a bit, you should be able to have mc sitting back, but his upper body should still move correctly for aiming. This will make it so his feet don't go into the floor of the hog.
Alternately, you could null it, then rename the turret marker to warthog_p_b and just rotate it by 3.142.
Also, if you lean its pitch back a bit, you should be able to have mc sitting back, but his upper body should still move correctly for aiming. This will make it so his feet don't go into the floor of the hog.
-
- Posts: 18
- Joined: Sun May 14, 2006 9:19 am
You'll want to set the yaw to 3.142 (probably--that's pi, which I believe is 180 degrees in radians). That should have him facing backwards. For his feet to be hanging over the back, I guess you'd just position him back there, but his legs will still go through the metal. Either that or he can be sitting on top of the back edge, I guess.
-
- Posts: 745
- Joined: Mon Feb 14, 2005 1:09 pm
- Contact: