Page 1 of 1
Sapien doesn't show anything...
Posted: Wed May 26, 2004 6:38 pm
by sorby
I followed the video tutorial and made a working level and everything worked fine. Then I started making my own level, still somewhat following the tutorial and everything worked right until I got to Sapien. I loaded up my .scenerio file but the sky did not show as it did in the tutorial map I made. I did the radiosity stuff but RIGHT after I entered radiosity_start, it showed all three numbers as zero. The screen was still black and the level was not visible. I could move around but I couldn't see anything. I know that it is not my RAM or anything because I have loaded the tutorial map in Sapien. Please help me.
Posted: Wed May 26, 2004 6:58 pm
by silencer88
radiosity_start then wait for it to go to zeroes (if its a less vertexed map it might only take a few seconds or no time at all)
THEN
radiosity_save
Posted: Wed May 26, 2004 7:12 pm
by sorby
As I stated, the zeros appear RIGHT after I enter in radiosity_start. There appears to be no loading whatsoever and I have done this with the other map so I know what I am talking about.
Posted: Wed May 26, 2004 7:17 pm
by hydroxic
how long did you wait, it takes a long time for some maps/ppl
Posted: Wed May 26, 2004 7:26 pm
by sorby
The problem is that I DON'T NEED TO WAIT. It should start at a relatively high number but mine STARTS AT ZERO. It allows me to go to the prompt immediately after the radiosity_start.
Posted: Thu May 27, 2004 12:06 am
by [35] ptr
If you do nothing you should see the sky direct. If not you probably did not set it or there is someting wrong with the sky ou selected.
Posted: Thu May 27, 2004 6:03 am
by sorby
It doesn't even show the sky and I did exactly what the tutorial said.