Radiosity start?

Italian_IcE · Post by **Italian_IcE** » Tue May 25, 2004 2:00 pm

when i do radiosity_start in sapien it says 0 0 0 and i left it about ten minutes now.

Blaze · Post by **Blaze** » Tue May 25, 2004 2:22 pm

That means it is done, type in radiosity_save.

KappaX · Post by **KappaX** » Tue May 25, 2004 2:27 pm

i thouhgt it was radiosity_start 0/1

Blaze · Post by **Blaze** » Tue May 25, 2004 3:09 pm

No, you first type in radiosity_quality <0 or 1> to set the quality, 0 for quick 1 for full radiosity. Then type in radiosity_start and wait till all the numbers equal 0. Then type radiosity_save to save it.

rec0 · Post by **rec0** » Tue May 25, 2004 9:33 pm

if it starts on 0 0 0 it isn't necessarily done actually.. if you have little vertices in your map it will read zero but can be still doing something, you just have to keep trying to click ~ and if you press it and it brings the command prompt up, its done so you type radiosity_save.

Blaze · Post by **Blaze** » Wed May 26, 2004 11:01 am

No, you can press ~ and save it at any time during the radiosity.

silencer88 · Post by **silencer88** » Wed May 26, 2004 2:51 pm

blaze is right

Lima14 · Post by **Lima14** » Wed May 26, 2004 3:06 pm

silencer88 wrote:blaze is right

Bump..

yeah, Ive found that I get a 0.000 0.000 0.0000 pretty quick if I dont have many vertices in my map, and also if it's a small one as well.

Ths first tim it happened to me, I thought radiosity hadn't done its job