Page 1 of 1
what is this? X2.3B Pro Dip Switch Settings
Posted: Tue Aug 17, 2004 7:06 pm
by rabiv88
I am not sure what this is and im sort of confused on what the instructions are trying to say... It was the last part of instructions for installing my modchip as u can see, and i dont quite get what they want me to do, lots of switching???
http://www.teamxecuter.com/x23b_pro_wires.htm here is the site/instructions that im trying to figure out, please help me if u can, thanx
Posted: Tue Aug 17, 2004 7:24 pm
by thinkreddie
post at
www.xbox-scene.com. This site is for modding halo, not the xbox
Posted: Tue Aug 17, 2004 7:28 pm
by rabiv88
ohh give me a break, to mod halo u need to first do these steps in order to achieve a successful instalation, so either help me or dont post at all, this forum i believe is called halo xbox modding general...
Posted: Wed Aug 18, 2004 12:26 pm
by RunningRiot
Actually, he is right about xbox-scene; not just because its doesn't quite fit in with the content here, but you would get much better help at xbox-scene.
However, I'll try to help out.
The last part of that guide is showing you different dip switch combinations for diffent BIOS slots when flashing and loading. Don't worry about the dip switch settings until you get it all soldered in.
Also, when you do start to look at the switch setting, it will depend on WHICH BIOS you are flashing(the size of it anyway).
-RunningRiot
Posted: Wed Aug 18, 2004 1:32 pm
by rabiv88
ok, now i understand, thanks a bunch