what is this? X2.3B Pro Dip Switch Settings

rabiv88 · Post by **rabiv88** » Tue Aug 17, 2004 7:06 pm

I am not sure what this is and im sort of confused on what the instructions are trying to say... It was the last part of instructions for installing my modchip as u can see, and i dont quite get what they want me to do, lots of switching???http://www.teamxecuter.com/x23b_pro_wires.htm here is the site/instructions that im trying to figure out, please help me if u can, thanx

thinkreddie · Post by **thinkreddie** » Tue Aug 17, 2004 7:24 pm

post at www.xbox-scene.com. This site is for modding halo, not the xbox

rabiv88 · Post by **rabiv88** » Tue Aug 17, 2004 7:28 pm

ohh give me a break, to mod halo u need to first do these steps in order to achieve a successful instalation, so either help me or dont post at all, this forum i believe is called halo xbox modding general...

RunningRiot · Post by **RunningRiot** » Wed Aug 18, 2004 12:26 pm

Actually, he is right about xbox-scene; not just because its doesn't quite fit in with the content here, but you would get much better help at xbox-scene.

However, I'll try to help out.

The last part of that guide is showing you different dip switch combinations for diffent BIOS slots when flashing and loading. Don't worry about the dip switch settings until you get it all soldered in.

Also, when you do start to look at the switch setting, it will depend on WHICH BIOS you are flashing(the size of it anyway).

-RunningRiot

rabiv88 · Post by **rabiv88** » Wed Aug 18, 2004 1:32 pm

ok, now i understand, thanks a bunch