Page 1 of 1
Milkshape n00b question..
Posted: Sat May 08, 2004 5:31 pm
by Matus
YES ITS A NOOBY QUESTION! DONT MEGA FLAME ME!
MilkShape:
how do i connect the dots?
i know how to put IN dots and all, but not connect them...
just answer the question and i will Delete it L8ter...
(i know they r not called dots and lines, i just like calling them that:)
Posted: Sat May 08, 2004 6:05 pm
by hydroxic
sry, cant answer, but i personally dont think you should use milkshape
use gmax or somthing else
Posted: Sat May 08, 2004 9:24 pm
by CovenantSpy
hydroxic wrote:sry, cant answer, but i personally dont think you should use milkshape
use gmax or somthing else
Wow you were a lot of help there. So whyd ont you keep your stupid opinions to yourself and not post next time.
Anyway I would like to know to. I'm new to milkshape and cant use it very well.
reply
Posted: Mon May 17, 2004 11:14 am
by risty1
the MS tool bar shud look like this
[select][move]
[vertex][face] etc
clik on face then in an anticlockwise direction clik the dots in a triangle this will create a face.
hope i helped
Posted: Mon May 17, 2004 11:48 pm
by maca_ยง
CovenantSpy wrote:hydroxic wrote:sry, cant answer, but i personally dont think you should use milkshape
use gmax or somthing else
Wow you were a lot of help there. So whyd ont you keep your stupid opinions to yourself and not post next time.
Anyway I would like to know to. I'm new to milkshape and cant use it very well.
wow you were a lot of help there too...