Page 1 of 1
Optimize Modifier
Posted: Sun May 08, 2005 11:21 am
by Patrickssj6
Is there a way where i can apply the Optimize Modifier to certain faces only?
Posted: Sat May 14, 2005 6:55 am
by Gavel
I don't think so, try going into face selection mode, and clicking optimize modifier. Might not work because, max always just applies it, and takes you out of the mode.
BTW try not to use that modifier, it can screw up your models. Say you have a very thin door. You use optimize and it might make that door weird. I can;t explain it, but it deletes some of the croner vertices, and makes it thin and odd.
Posted: Sat May 14, 2005 7:12 am
by Patrickssj6
no it worked.i aked sonictag and it worked but i got some errors but thank anyway
Posted: Sat May 14, 2005 7:39 am
by Gavel
Ah, ok.
Posted: Sat May 14, 2005 7:40 am
by Waverunner
Patrickssj6 wrote:no it worked.i aked sonictag and it worked but i got some errors but thank anyway
How did you do it?
Also, why is this in mapping? (lol?)
Posted: Sat May 14, 2005 7:45 am
by Patrickssj6
select faces optimize modifier and then convert to editable mech like the uvw mapping