model:MP5(blackhawk down)

[Elite_Green_Devils]

this is my MP5 sub-machine gun. made from scratch note the very bad 3p model kuz i was lazy. here.best used with a scratchy black overpaint due to complications

[sharpshot2492]

What does it replace?

[Butt Cancer]

that looks ok, but there are major problems with this model: 1st is the magazine is not curved, as it should be, 2nd is that the front and back sights should be raised, 3rd is the stock, that needs just more realistic improvement, and the front handgrip, which should be less blocky and more roundy
hope this hepls a little bit

~Butt Cancer
o btw, 5/10 so far

[Elite_Green_Devils]

that looks ok, but there are major problems with this model: 1st is the magazine is not curved, as it should be, 2nd is that the front and back sights should be raised, 3rd is the stock, that needs just more realistic improvement, and the front handgrip, which should be less blocky and more roundy
hope this hepls a little bit

~Butt Cancer
o btw, 5/10 so far

its in beta.

[Billy3764]

that looks like an MP5 J (Japan) My friend has an airsoft version.

[Spartan_0214]

meh, 6/10

-1 the magazine isn't bent
-1 the shoulder stock is too close to the butt
-1 the grip is fuzzy and not flesh with the barrel
-1 the magazine is sticking out and isn't bent far enough back

[UPS]

That looks like it replaces the pistol.
Firstly, you should add more overall meat to the model. Try pulling down the trigger, trigger guard, and handle. Also, curve the magazine.

[auerhantheman1]

What they said, and make it so the handle doesn't look like a pistol grip with an extended magazine. Good work so far.

[Elite_Green_Devils]

What they said, and make it so the handle doesn't look like a pistol grip with an extended magazine. Good work so far.

like i said its in beta and i was out of ideas and i didin't feel like moving the clip to the front so not that i have ideas i will work on it.

[GKMods]

How do you use milkshape for modeling is there a plugin that you need?

[Jsk1610]

Looks very nice for a remodel.. Some people who have been saying it's not very good may not know that you only used the pistol to make that model.. You're getting there, it just needs a little more work. If you're milkshape has an extrude tool, then use that. It's a very helpful tool to make faces to create new faces to work with. If it doesn't have an extrude tool, use what i use.
http://www.wings3d.com/

[sharpshot2492]

I have problems with wingd 3d. when I try to import an edited model back into HMT it has too many indices.

[Elite_Green_Devils]

I have problems with wingd 3d. when I try to import an edited model back into HMT it has too many indices.

wings 3d doens't work with halo.